[Qingyuan NTN Bearing agents] (INA bearings agent) 
 [Qingyuan NTN Bearing agents] (INA bearings agent) 
 The thrust bearing is installed correctly, the seat can automatically adapt to the rolling of the rolling element, to ensure that the rolling element is located in the upper and lower ring raceway. If installed backwards, not only bearing is not working properly 

 Often, and with the surface would be subjected to severe wear. Shaft washer with the seat and the difference is not very obvious, the assembly should be careful not to mistake. In addition, the thrust bearing 

 Should be left between the seat and the bearing hole 0 2-0. 5mm gap to compensate for the machining of parts, installation inaccurate error, when the bearing ring operation 

 Center offset this gap to ensure that automatically adjust to avoid touching the friction, its normal operation. Otherwise, it will cause severe damage of bearings. 
 Commissioning 
 Commissioning test bearing noise, temperature, and vibration to meet the requirements. The general bearing operating temperature should be below 90 ° C, when the temperature is too high will lead to bearing heating 

 Annealing or burning, reduce service life. 
 [Qingyuan NTN Bearing agents] (INA bearings agent) 
 1 Bearing Installation examples 
 1 Jiefang type CA10B truck universal joint parts of the cross bearing installation 
 First needle a little butter, paste in the bearing shell, fitted with seals, and in turn the cross shaft mounted Yokes (butter mouth side toward the drive shaft), the bearing shell 

 Mounted on the drive shaft fork. To prevent damage to the mechanical, hand hammer the installation of the bearing shell, do not use too much force, and shall not be fitted in migraine. And then use the old bearing shells than bearing 

 Smaller shell diameter copper rod into the clamp rely on Taiwan, to expose the ring ring until the locking pin from the locking plate, locking pins or screws fastening. 
 After installation, the hand plate moving cross shaft to test the tightness of the free rotation is appropriate to make the cross shaft. Avoid bearing shell and seal. 
 2. Harvest